The shot above shows a repair done to one of the axles after a mishap, (it’s quite heavy!) using a panel pin.
This one shows some dial faces that I drew as none are included. They are about 2.5mm diameter.
The fording logs were added, after I saw them growing in the grounds of my workplace, they looked so good to scale!
Other than the paints stated, there is a 1:16 resin jerry can on the left hand side, a couple of pieces of small gauge chain holding the fording log, a piece of guitar wire for the aerial, and a small amount of Hanley bus station car park rubble, which is being dug up!!
These two shots show a lot of small items ready to be sprayed, held by double sided foam tape. Fabulous stuff that holds by the smallest contact area, and grips like a vice!
Finally, the grass effect on the underside is Tamiya, and looks great.
The kit contains everything else required really.
Hope that you like it?
(PS – I will be working on the figure and a base soon, but don’t really have a context yet other than the monotone look of the tank against the rubble on the base. DS)